- #Technicolor modem dpc3216 how to
- #Technicolor modem dpc3216 upgrade
- #Technicolor modem dpc3216 software
It does not disconnect users that are connected.
The busyout service tells the router to busyout modems on a given modem card until all six of the modems are free.
#Technicolor modem dpc3216 upgrade
The reboot service delays the upgrade until the next reboot of the system. Remember, Modem ISDN Channel Aggregation (MICA) modems must be upgraded in groups of six, because that is how many modems are built onto each modem card. The router prompts you to choose the type of service to use in order to upgrade the modems. In this example, the file is in flash memory located in the images directory: Name of file to copy? images/c5300_portware1-1 If you are not sure where the file resides, use the show flash command in order to find the file.
#Technicolor modem dpc3216 software
The version of Cisco IOS software you use determines if you need to tell the system the directory or memory area where the file resides. The router prompts you to choose the file to copy to the modems. In this example, modems 12 through 23 on the second modem carrier card are upgraded: Modem Numbers (/ | group | all)? 2/12-2/23 Usually, you upgrade all of them, but this feature is useful if the access server runs more than one type of modem. The router prompts you to enter the modems you want to upgrade. The remainder of this document describes different firmware/portware upgrade scenarios.Ĭisco AS5xxx Cisco IOS Software Release 12.0(5)T and EarlierĬomplete these steps in order to upgrade the firmware/portware on an AS5200/AS5300 with Cisco IOS Software Release 12.0(5)T and earlier: The modem uses the firmware version that is bundled with the current Cisco IOS software, unless you explicitly configure it to behave differently. It is possible to have multiple versions of portware loaded in flash memory. Load the new firmware/portware into the digital signal processors (DSPs) of the modem. If you do not see the new file, make sure nothing failed during the transfer process. Look for the new firmware/portware image in order to verify its presence. Whichever method you use, the show flash command lists the files that are currently stored locally. Refer to the software installation instructions of your hardware for more information.Ĭisco IOS Software Release 11.3T introduces a new command that allows you to use FTP instead of TFTP. You upload the software from a TFTP server in much the same way that you upload new Cisco IOS® software: router# copy tftp flash Modem Firmware/Portware Upgrade ProcedureĬomplete these steps in order to upgrade the firmware/portware on your modems:Ĭopy the firmware/portware file into flash memory from a TFTP server. Refer to Cisco Technical Tips Conventions for more information on document conventions. If your network is live, make sure that you understand the potential impact of any command.
All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. This document is not restricted to specific software and hardware versions. There are no specific requirements for this document.
#Technicolor modem dpc3216 how to
Refer to Analog Modem Firmware Upgrade Configuration Note for more information on how to upgrade the code on the analog modem modules. Note: This document does not describe the portware upgrade procedure for analog modems in the NM-8AM and NM-16AM modules. Refer to the software installation instructions of your hardware for more information on the upgrade process. Alternatively, you can use the newer File Transfer Protocol (FTP) copy. This document assumes you already have a Trivial File Transfer Protocol (TFTP) server that contains the new modem firmware/portware images you need to load onto your router. This step-by-step guide describes the firmware/portware upgrade process for Cisco routers with digital modems.
0 kommentar(er)
